The Lego Pc Build Project Thread!

Ok so ive been thinking about fan placement for the case. In order to have as mush lego visible as possible i am oly putting fans in the back of the case where they cant be seen and on the top/lid. Basically the case is going to be modled after the danger den torture rack. 2 layers, mb on the top. So on top i am going to put 6 120mm fans in a formation like this. These will probably be all intake.

0 0
0 0
0 0

Then in the back i am going to put 4 120 mm fans in a formation like this. (the underlining is a representation of the separate layers. The two on top are eshausts and im not sure about the bottom 2 yet.

0 0
0 0

What do you all think of this setup?
 
heck of a lot of fans! If I were you, I'd make one bottom intake, and one bottom exhaust, get a little air flow in there. I'm not going to use as many fans, just have an intake or two, with perforated lego blocks. maybe a small exhaust at the bottom, but mine's going to be simple. lol
 
You must log in or register to reply here.
Back
Top