Opinion on ASrock mobos

I've only ever used one ASRock motherboard, built my parents a computer 7 years ago and it's still going strong. I did have some intermittent memory issues at one point (after going to 64-bit from 32-bit, DDR2 board though), but I ended up putting in a new set of sticks and updating the BIOS and that seemed to fix it.
 
johnb35 said:
Look on page 70 of the manual and you'll see where it says load XMP setting.
Click to expand...

Is this in the manual for my asrock z97 extreme 4 board? I'll take a look in the manualab when I get home. There must be a setting because in task manager my new ram is running at 1600mhz but the spec is 1866
 
Yes, its in your manual. Your board only supports up to 1600mhz without physically overclocking the ram, hence why you enable the xmp setting and it will go up to 1866mhz. Just make sure the timings match the ram. If not, you have to manually change them.
 
Considering that I just overcame this issue and ran a clean memtest I hope enabling this setting doesn't cause any issues in the future!
 
Renzore101 said:
Considering that I just overcame this issue and ran a clean memtest I hope enabling this setting doesn't cause any issues in the future!
Click to expand...
If it massed Memtest your good. Even with "incorrect" settings, as long as your system boots it should still work, just maybe not as efficiently as it would with the proper settings.
 
Overclock instability perhaps... Have you run crystal disk info? It is free and will tell you if your drive is not healthy.
Have you altered your BCLK (if using an Intel system)?

Have you changed SATA controller modes in BIOS since installing windows? (IE going from AHCI to RAID)
 
Intel_man said:
Changing from IDE to AHCI in the BIOS won't give you a BSOD. It will flat out tell you you're missing the BOOTMGR. It won't even get to the point where you'll BSOD.
Click to expand...
Yes it will - kind of. In Windows 10 it's not blue anymore. It will give you a INACCESSABLE_BOOT_DEVICE and reboot unless you change the registry to load the correct miniport driver (and installed it if it is not already).
 
Cromewell said:
Yes it will - kind of. In Windows 10 it's not blue anymore. It will give you a INACCESSABLE_BOOT_DEVICE and reboot unless you change the registry to load the correct miniport driver (and installed it if it is not already).
Click to expand...
Hmmm... interesting. I don't recall ever making it that far when I changed it to AHCI.
 
You must log in or register to reply here.
Back
Top