Would Some check this and see if I did it correctly

theblackdragon

theblackdragon

New Member
OK, I gotta know if I did something wrong, or I if I have a defective part. So I am going to detail what I did.

I attached the 2 internal fans and run the wires. Then I attached the power supply. I screwed in all the support studs. I attached the CPU to the motherboard putting the arrow in the proper corner, and closing the lock. The CPU didn't move and there was no seam visible. I attached the heatsink and fan, tested them by powering up the motherboard for a second to allow the fan to start. I then placed the motherboard into the case and attached it to the studs being careful not to overtighting the screws. I installed the RAM module and video card. I put the hard drive and DVD ROM in and connected the sata cable to the hard drive and IDE cable to the DVD ROM. Then I connected the power cables. I connected the the the connectors for the lights, internal speaker, and the front USB posts. I checked to make sure all fans were connected to the proper places. Then I booted up the system and went into the BIOS. I set the BIOS to boot from the DVD ROM and inserted the Windows Vista disk.

Is this correct, or did I miss something?
 
This sounds okay but is it actually working as you havent even said if its worked or not. As if its working then youve done everything correctly :D
 
You must log in or register to reply here.
Back
Top